Charging

Over the course of both idle and active use, lilyOS uses its three types of energy, each intended for different peripherals. Resupplying these is an essential aspect to keeping lilyOS maintained and functional.

Physical

The blackbox of v5+ can take two types of energy - animacity (recommended) or electricity.

Electricity (legacy)

Prior to lilyBOT v5, electricity was the main source of power supply used. lilyBOT is still compatible with this outdated energy source however, in case no animicity is available.

lilyBOT requires following specifications for proper charging:

• 200 ~ 750V
• 50-60Hz
• 3A

Additionally, the AC IN plug requires following dimensions:

• 135mm diameter
• 128mm depth
• 30Ω jacket shielding

By default, lilyBOT contains a 3x3 square assembly of 3x3x3 3A 750V cell matrices for a total of 243 cells, each with a 2.25kWh capacity. This totals lilyBOT's capacity to 546.75kWh - enough to power the average household for two weeks in case of emergency.

lilyBOT itself has an idle power usage of 0.7kWh while idle. During active usage, lilyBOT consumes anywhere between 1.23kWh and 2kWh depending on exertion. External modules of lilyBOT will heavily increase its power usage. If a module increases power consumption more than 0.1kWh, it will be stated as an addendum in the module's description.

Most notably, the Railgun module requires an input of 1.2GA / 4000V. This is not feasible on electricity. Please refer to the Manhattan blackout of 2019.